How to change a Recotoner ink cartridge?

Do you have an HP printer that needs to change cartridges ? We know that these types of procedures can sometimes be scary, especially when you have little knowledge about the subject. Performing a step incorrectly, moving any of the pieces, leaving it poorly adjusted and the ink starting to leak out of the container, lower quality prints, are just some of the things that can result in total chaos. So that this does not happen to you, learn how to change an HP ink cartridge in a simple way.

Steps to change an ink cartridge in an HP printer

The steps that we present below are simple to carry out, you will see how in a few minutes you will have completely new Recotoner cartridges in your HP printer and you will be able to continue using it as usual.

It is important that you follow these instructions to replace Recotoner cartridges in your HP printer, being careful not to skip any steps.

1. To start make sure to turn on the printer.
2. You need to put some sheets in the special paper tray. They don't have to be new, just properly installed.
3. Once the pages are placed, you must open the cover where the cartridges are located.
4. Wait until the moving carriage containing the cartridges is right in the center of the printer.
5. When this happens, simply press the cartridge you want to change and slowly remove it. If it involves multiple cartridges, go easy and make sure to do the process one by one.
6. Before inserting the new cartridge, make sure that you have removed all the seals that are not necessary for the printer.
7. If it is already in perfect condition to be placed, you just have to install it in the same place where the previous one was. You must press very carefully until you hear a sound indicating that it has fitted correctly.
8. When you are done with all the cartridges you wanted to change, you just have to close the cover and that's it, the printer will initialize and recognize them.

How to extend the life of Recotoner ink cartridges?

Depending on how you use a printer, changing ink cartridges regularly can be considered expensive. By knowing some ways to care for them, it is possible to prolong their useful life and prevent them from going bad before they are completely used up. Here are some tips:

• You should not wait for the cartridges to completely use up their ink before replacing them with a new one. When they do not have enough ink to print, they begin to burn fuel, affecting the printer.
• When you finish changing the ink cartridges, at least two prints must be made so that the cartridges can settle.
• The printer must be placed in such a way that the cartridges are kept vertically to prevent the colors from mixing with each other.
• Cartridges should be kept in a cool environment, away from the sun and where they do not receive an excessive amount of heat because this automatically and permanently damages them (dries them out).
• If the prints begin to show lines or dots that were not expected from the beginning, it is necessary to clean the cartridge head.
• The cartridges should not be shaken, this damages them and prevents them from being reused again.

Changing cartridges in an HP printer is not as complicated as it may seem at first. We know that with these instructions and tips that we have provided you will be able to do it correctly on your own.